User's Manual
Table Of Contents
- ExtendAir® G2™ 24GHz Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- SSH or Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- ATPC Configuration Page
- Alarms Page
- Performance Page
- ATPC Statistics Page
- Ethernet Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
ExtendAir G2 24GHz Digital Microwave Radios
58 209866-002
2015-09-09
Ethernet Performance Page
This page displays statistics related to Ethernet traffic to assist with troubleshooting and for general
performance monitoring. These statistics are aligned with the Remote Network Monitoring (RMON)
convention, RFC 2819 (http://tools.ietf.org/html/rfc2819
).
Figure 33 Ethernet Performance page
• The Update Interval field accepts entries from 1–20 sec.
• Drop Events field indicates the total number of packets dropped due to traffic exceeding Radio RF
capacity.
•Octets
• Total Transmitted Packets fields indicate the total number of (Unicast, Broadcast, or Multicast)
packets from the radio out toward the user equipment.
• CRC Align Errors indicates
• Undersize/Oversize Packets fields indicates the number of these packets received.