User's Manual
Table Of Contents
- ExtendAir® G2™ 24GHz Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- SSH or Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- ATPC Configuration Page
- Alarms Page
- Performance Page
- ATPC Statistics Page
- Ethernet Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
ExtendAir G2 24GHz Digital Microwave Radios
52 209866-002
2015-09-09
Alarms Page
This page provides an easy-to-read summary of the alarm status of both local and remote radios. The
colors on this page reflect the color of the alarms displayed on the radio front panel. However,
additional detail displays on this page to aid in quick assessment of issues and status.
Figure 30 Alarms page
Table 6 lists alarm status conditions that appear on this page.
Table 6 Alarm status indicators
Label Status
Link Indicates RF link status:
• Green Solid = Error-free connection (BER<10e-6)
• Yellow Solid = Errored connection (10e-3>BER >10e-6)
• Red Solid = No link (BER>10e-3)
ATPC Max (ATPC enabled) Indicates Automatic Transmitter Power Control maximum range status:
• Green Solid = ATPC enabled, maximum range not active
• Yellow Solid = ATPC maximum range active
• Grey = ATPC disabled or ATPC Timer Control disabled
• Red Solid = Radio Link down and maximum range active for >5 minutes
Ethernet • Green Solid = Alarm enabled and Ethernet link present
• Red = Alarm enabled and Ethernet link not present
• Grey = Alarm disabled