User's Manual
Table Of Contents
- ExtendAir® G2™ 24GHz Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- SSH or Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- ATPC Configuration Page
- Alarms Page
- Performance Page
- ATPC Statistics Page
- Ethernet Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
ExtendAir G2 24GHz Digital Microwave Radios
38 209866-002
2015-09-09
System Configuration Page
This page contains several critical system parameters.
Figure 22 System Configuration page
Most entries on this page are self-explanatory. The following lists unique or important parameters.
• Set the Diplexer/Filter Configuration parameter to match the installed diplexer of the radio (see
Diplexer (Channel Plan) Configuration
).
– 871–Use this setting for horizontally oriented diplexers.
– 872–Use this setting for vertically oriented diplexers.
Note: The diplexer settings for both radios must match.