User's Manual

Exalt Installation and Management Guide
ExtendAir G2 24GHz Digital Microwave Radios
209866-002 37
2015-09-09
File Activation Page
Use this page to move stored or uploaded files for use on the radio. The page indicates which file is
currently in use, and which file is available for use. Click the Swap button to place the file in the
Alternative File column into the active state and move the file in the Current File column to the
Alternative File column.
Figure 21 File Activation page
To load the original firmware that shipped with the radio, use the Revert function. Note that reverting
may cause loss of some functionality, as the current firmware may support features not originally
supported.
When reverting, the current file moves to an alternate file location and the original factory firmware
becomes current. If you swap back to the original firmware and no new file has downloaded to the
alternate file location, the original alternate file is restored to the alternate file location resulting in the
configuration you started with before you reverted. New firmware always downloads to the alternate
file location, and must be swapped to become the current firmware.
All other radio configurations are maintained. The radio does not return to factory settings,
just the original factory firmware.
Note: In all cases, the radio reboots after a new file is selected using the Swap function. This
places the radio out of service for a short time.