User's Manual
Table Of Contents
- ExtendAir® G2™ 24GHz Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- SSH or Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- ATPC Configuration Page
- Alarms Page
- Performance Page
- ATPC Statistics Page
- Ethernet Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
ExtendAir G2 24GHz Digital Microwave Radios
34 209866-002
2015-09-09
File Transfer Page
This page allows the administrator to upload and download files to and from the radio. Two types of
files can be uploaded: configuration, and radio firmware. When uploading Configuration Files,
current configuration parameters are immediately overwritten, and the unit may reboot if
configuration changes require a reboot. When uploading radio firmware files, the file is placed into
reserve memory space. After the new radio firmware file uploads, use the File Activation page to
enable the files (see File Activation Page
).
Figure 18 File Transfer page
These types of files can be downloaded: configuration, MIB, Snapshot, and event log. The MIB file
refers to the Management Information Base related to the Simple Network Management Protocol
(SNMP) function, and is only available on models which support SNMP. See S
imple Network
Management Protocol (SNMP) Configuration for more information.
Use the following steps to upload a file:
1 Select the type of file to upload (Radio Firmware or Configuration).
2 Click Browse and choose the file to upload.
The file name being uploaded appears next to the Choose File button.
3 Click Upload to Radio.
Note: Check the File Activation Page before uploading radio firmware files. New file uploads
overwrite the secondary file location. If important files reside in the primary or secondary file
location, download them before uploading the new files. Only the active radio firmware file
can be downloaded. Therefore, to download the reserve file, it must first be activated (using
the Swap button).