User's Manual

Exalt Installation and Management Guide
ExtendAir G2 24GHz Digital Microwave Radios
209866-002 25
2015-09-09
If all other parameters are still configured at their factory default settings, the radios can now be
connected back-to-back to verify that the link is communicating and perform any other desired tests.
See Back-to-back Bench Testing
for test information.
Navigating the GUI
describes each page of the GUI. Most configuration parameter settings are
intuitive. The following link parameters must match at both ends for the link to communicate:
• Link Security Key (Administration Settings Page
)
•Bandwidth (System Configuration Page
)
• Modulation (System Configuration Page
)
• RF Frequency (System Configuration Page
), the channel plans match, but are opposite Tx and Rx
frequencies for a link.
Navigating the GUI
The GUI provides the primary interface for all configuration and management. There are three sections
of the main GUI window, as shown in Figure 11:
• Summary status information pane (upper-left corner)
• Navigation pane
• Main window
Figure 11 Exalt GUI window description
Summary Status Section
This section of the Exalt GUI provides a review of the system status.
In the screens in Figure 12, the top bar illustrates the alarm condition of the link. The information
inside the bar is equivalent to the entry of the Link Name set by the administrator in the Administration
Settings page.
Note: Changing any of these parameters causes a temporary loss of link. The GUI displays a
warning and provides an opportunity to cancel changes.
Note: Click the radio IP address link to access that radio for management.
SUMMARY STATUS
NAVIGATION PANE
MAIN WINDOW
LINK TO
REMOTE RADIO