User's Manual
Table Of Contents
- ExtendAir® G2™ 24GHz Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- SSH or Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- ATPC Configuration Page
- Alarms Page
- Performance Page
- ATPC Statistics Page
- Ethernet Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
ExtendAir G2 24GHz Digital Microwave Radios
18 209866-002
2015-09-09
3 Use a 0.5mm hex wrench to remove the eight (8) screws shown below on the diplexer housing.
With the handle up, the labels on the diplexer housing indicate the Tx frequency (on the left side).
4 Turn the diplexer 180° or exchange the diplexer.
5 Re-mount the properly oriented assembly and secure it to the chassis using the eight (8) hex screws
removed in Step 3.
6 Place a thin layer of silicone lubricant (provided) on the outer edge of the diplexer O-ring gasket.
7 Replace the cover and secure the four (4) Hex screws on the radio chassis,
CAUTION! Do not pinch the rubber O-ring gasket.
HANDLE UP
DIPLEXER
CONFIGURATION
CURRENT
INDICATE
LABELS