User's Manual
Table Of Contents
- ExtendAir® G2™ 24GHz Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- SSH or Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- ATPC Configuration Page
- Alarms Page
- Performance Page
- ATPC Statistics Page
- Ethernet Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
ExtendAir G2 24GHz Digital Microwave Radios
14 209866-002
2015-09-09
LED Indicators
Figure 6 shows the LED locations for the ETH connectors relative to the RJ-45 release tab.
Figure 6 RJ-45 LED orientation
Table 4
provides details of the LED indicators on the ExtendAir G2 24GHz radios. Note that there are
two LEDs, left and right, associated with each connector. See Alarms Page
for information on how the
Exalt GUI displays LED status.
Table 3 Connectors
Connector Description
RSL
(BNC female)
Antenna alignment RSL voltage (during installation)
Used for radio reset
Power/ETH1 Connected cables traverse to the power injector (Data+Power side), and provide
the following functions:
• Primary ports for user Ethernet data to traverse link (10/100/1000 BaseT)
• DC power from power injector
ETH2 Port for an additional Ethernet connection; management and/or traffic.
(Ground) Threaded (M6) receptacle.
Note: Use a connector cover on all unused connectors for weatherproofing. The connector
covers are included with shipped units.
Table 4 LED indicators
Location/Label Type Function
ETH2 (LEFT) Green
LED
Solid = Ethernet link present.
ETH2 (RIGHT) Green
LED
Flash = Ethernet link present.
ETH1 (LEFT) Green
LED
Flash = Ethernet link present.