User's Manual
Table Of Contents
- ExtendAir® (TDD) Series Direct Mount Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir® (TDD) Series Direct Mount Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- Simple Network Management Protocol (SNMP) Configuration
- File Management Pages
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- VLAN Configuration Page
- Ethernet Rate Limiting
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Conducted Power Limits for the United States and Canada
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir
®
(TDD) Series Direct Mount
000000-001 107
2011-08-26
Power connector 78
power interface 76
Power/Ethernet connector 23
R
radio
default settings 9
grounding 84
initiation tasks 17
installation tasks 17
maximum transmit power setting 48
mounting 5
rebooting 64, 72
Radio A 9
Radio A configuration 6
radio configuration 6
radio firmware files 43
Radio Information page 37
Radio Transmit Power parameter 47
Reboot page 72
receiver threshold 5
record keeping 18
Regulatory Domain Database (RDD) 43
Regulatory Domain Key (RDK) 39, 47
regulatory requirements
EIRP 93
USA 90
repeater 11
RESET button 24
RF connection termination 25
RF Frequency parameter 48
RF interface 76
RF interference 83
RF output power 8
RSL 8
current RSL readings 62
diagnostics 67
Maximum RSL field 63
Minimum RSL Timestamp field 63
monitor for performance 82
RSL Sync 77
RSL voltage 28
S
safety 88
Set to E1 button 53
Set to T1 button 53
shipping box contents 6
site preparation 5
SNMP 16, 40
SNMP Traps 41
specifications 74
Spectrum Analyzer page 69
Swap button 44, 46
sync distribution accessory 78
sync source 14
synchronization 11
System Configuration page 47
system latency 5
system parameters
default settings 27
system performance 62
system reboot 64
system settings
Current BER field 62
Errored Seconds (ES) field 63
grounding 84
Maximum RSL 63
Minimum RSL field 63
Time Since Reset field 63
Unavailable Seconds field 63
system specifications 74
T
T1 Interface Configuration page 53
T1/E1 1&3 connector 23
T1/E1 2&4 connector 23
T1/E1 2&4 LED 24
T1/E1 circuits 53
T1/E1 Configuration page 53
T1/E1 interfaces 76
T1/E1 loopback 55
TDD factors 8
TDD frame length 6
TDD Frame Size parameter 49
TDM circuits 48
TDM connections 77
TDM connectors 77
Telnet menu 30
Telnet session 30
temperature 67, 74
testing 86
back-to-back bench 7
threshold 87
threshold testing 87
time division duplex (TDD) SeeTDD frame
Time Since Reset 63