Installation Manual
Table Of Contents
- ExtendAir eMIMO Series Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir eMIMO Series Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization (future feature)
- Radio Synchronization (future feature)
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP) (future feature)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI) (future feature)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- File Management Page
- System Configuration Page
- VLAN Settings Page
- Antenna Alignment Page
- Performance Page
- Metrics – Link Statistics and Radio Interface Statistics Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance–TBD
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty Software License and RMA Procedures Agreement
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir eMIMO Series Digital Microwave Radios
208363-001 100
2013-05-01
Power/ETH1 21
License Key 34
lightning arrestor 5
lightning arrestors 25
link 5
orientation 8
RF link testing 7
synchronization 8
Link Distance parameter 38
link margin 67
Link Name parameter 36
link parameters 30
login names 29
login privileges 29
M
Minimum RSL field 41
mounting
hardware 19
multi-link network 11
multipath 64
multipath propagation 65
N
noise profile 5
O
offset timing 13
P
passwords 7, 29, 36
path obstruction 66
performance degradation 64
Performance page 41
Power connector 55
power interface 53
Power/Ethernet connector 20
R
radio
default settings 9
grounding 66
initiation tasks 17
installation tasks 17
mounting 5, 19
rebooting 44
Radio A 9
Radio A configuration 6
radio configuration 6
Radio Information page 32
Radio Name parameter 35
Radio Transmission Status parameter 37
Radio Transmit Power parameter 38
receiver threshold 5
record keeping 18
regulatory requirements
EIRP 81
USA 75
repeater 11
Reset page 44
RF connector termination 21
RF Frequency parameter 36
RF interface 53
RF interference 65
RF lightning arrestor 25
RF output power 8
RSL 8
current RSL readings 41
monitor for performance 64
RSL Sync 55
RSL voltage 26
S
safety 71
shipping box contents 6
site preparation 5
SNMP 15
specifications 47
sync distribution accessory 55
sync source 14
synchronization 10
system latency 5
system performance 41
system settings
Current BER field 41
grounding 66
Minimum RSL field 41
system specifications 48
T
T1/E1 2&4 LED 21
TDD factors 8
TDD frame length 5
Telnet menu 27
Telnet session 27
testing 69
back-to-back bench 6
threshold 70
threshold testing 70
time division duplex (TDD) SeeTDD frame
timing, offset 13