Installation Manual
Table Of Contents
- ExtendAir eMIMO Series Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir eMIMO Series Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization (future feature)
- Radio Synchronization (future feature)
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP) (future feature)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI) (future feature)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- File Management Page
- System Configuration Page
- VLAN Settings Page
- Antenna Alignment Page
- Performance Page
- Metrics – Link Statistics and Radio Interface Statistics Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance–TBD
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty Software License and RMA Procedures Agreement
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir eMIMO Series Digital Microwave Radios
99 208363-001
2013-05-01
Index
A
access filtering 34
Administration Settings page 33
administrator privileges 29
AES License key 36
Antenna Gain parameter 38
Antenna Type parameter 38
antennas
alignment 25, 66
Canada 76
mounting 22
indoor 25
mounting height 5
site preparation considerations 5
transmission line 23
troubleshooting 66
B
back-to-back bench test 6, 69
back-to-back bench test configuration 69
Band parameter 37
Bandwidth parameter 36, 37
browsers 28
C
cables
Ethernet (CAT5e) 7
RF 5
troubleshooting
improper RF cable termination 65
Channel parameter 37
CLI 27
main menu 27
connections
RSL Sync 55
sync distribution accessory 55
Two-radio pin Internal Sync Out/In 55
connectors 20
GPS/RSL 20
Power/Ethernet 20, 55
Current RSL field 41
D
date and time 33
DC power source 21
dimensions 47
E
effective isotropic radiated power (EIRP) 8
Endpoint Identifier 36
Endpoint Identifier parameter 37
Ethernet connectors 55
Ethernet interface 53
F
factory default settings 35
fade margin 5, 67
files
default configuration file 35
flywheeling 14
frame length See TDD frame
frequency
center 5
G
GPS/RSL connector 20
GPS/RSL LED 21
grounding 66
GUI
Administration Settings page 33
browsers supported 28
description 28
IP address (default) 28
log in 28
login privileges 29
Performance page 41
Radio A configuration 28
Radio Information page 32
Reset page 44
VLAN page 39
H
hub 11
I
interfaces
Ethernet 53
power 53
RF 53
interference profile 5
Internal Sync Out/In (two-radio pin connec-
tion) 55
IP address 36
IP address conflicts 28
IP address subnet 28
IP settings 7
L
LEDs
ETH2 or ETH3 21
GPS/RSL 21