User's Manual
Table Of Contents
- ExtendAir® (TDD) Series Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- Notes for Customers of the Cisco Configuration ExtendAir r5005
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir (TDD) Series Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Management Pages
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- VLAN Configuration Page
- Ethernet Rate Limiting
- QoS Configuration Page
- Automatic Channel Selection (ACS) Page
- Syslog Configuration Page
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Regulatory Domain Keys
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty Software License and RMA Procedures Agreement
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir (TDD) Series Digital Microwave Radios
68 203591-010
2012-09-04
Automatic Channel Selection (ACS) Page
Use this page to configure alternate channels that the radio uses to automatically re-establish the link in
the event of qualified radar detection (for DFS enabled radios) or if the trigger parameters are
exceeded. Define up to ten alternate channels. Up to five channels can be enabled at the same time.
Figure 42 Automatic Channel Selection page
ACS is disabled by default to prevent accidental interference to other systems in the vicinity or impact
multi-site frequency planning in the event of a channel switch, particularly in collocated environments
designed to operate on the same channel or predefined traffic asymmetry configurations.
Enable ACS to configure alternate channels. Enter the desired frequency for up to ten alternate
channels. Only up to five channels can be enabled at any time. Clicking Update saves the settings and
pushes the configuration to the other radio on the link if the link is currently operating in both
directions. ACS configuration is not enabled until the ACS option on the System Configuration Page
is
selected and Update selected.
Note: To preserve the link, both Radio A and Radio B must have ACS enabled
and the channel frequency settings must match. If only one radio has ACS enabled
and an ACS event is detected, that radio will switch channels and the other radio will not, and
the link will be lost.
Note: If an event is detected that triggers ACS, traffic is interrupted.