User's Manual
Table Of Contents
- ExtendAir® (TDD) Series Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- Notes for Customers of the Cisco Configuration ExtendAir r5005
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir (TDD) Series Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Management Pages
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- VLAN Configuration Page
- Ethernet Rate Limiting
- QoS Configuration Page
- Automatic Channel Selection (ACS) Page
- Syslog Configuration Page
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Regulatory Domain Keys
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty Software License and RMA Procedures Agreement
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir (TDD) Series Digital Microwave Radios
116 203591-010
2012-09-04
Regulatory Domain Keys
Exalt radios are designed to allow the professional installer to select frequency bands, determine signal
bandwidths, tune center frequencies, limit output power, and enable or disable DFS options as
permitted by regional regulations. For models with the Regulatory Domain Key (RDK) feature, the
radios ship with the RDK information empty and the radio cannot be enabled without a valid key. The
partner, distributor, or installer is responsible for installing the RDK based on the final installation
country of the radio. Exalt issues RDK information to their distributors when ship-to country
information is provided. Consult your local Exalt distributor or reseller to obtain the RDK.
Countries are assigned to different regulatory domains based on current regulatory requirements. Each
regulatory domain has the parameters set to ensure that when the radio is turned on, the default settings
are complaint for local laws.
Regulatory Domain Keys are assigned by regulatory domain based on the local regulations.
Caution! It is critical that the RDK be set to the correct default setting so that the local
regulations for the installation requirements are met.
Table 9 4.9GHz Regulatory Domain Keys
Regulatory Domain
Key Name
Bandwidths Countries
049A0 10MHz
20MHz
USA, Canada
049A1 10MHz
20MHz
40MHz
Malaysia
Table 10 5GHz Regulatory Domain Keys
Regulatory Domain
Key Name
Frequency Band(s) Countries
053A0 5.3GHz,
5.4GHz (DFS),
5.8GHz
Singapore, Philippines
053A1 5.3GHz (DFS),
5.4GHz (DFS),
5.8GHz
USA, Canada
053A2 5.8GHz China, Taiwan
053A3 5.3GHz
5.8GHz
Mexico
053A4 5.3GHz (DFS),
5.4GHz (DFS),
5.8GHz (DFS)
Channelized: EU, Egypt, Ghana
053A5 5.4GHz (DFS),
5.8GHz
Channelized: Australia
053A6 5.3GHz,
5.4GHz,
5.8GHz
Unrestricted