User Manual
Table Of Contents
- ExtendAir® (TDD) Series Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- Notes for Customers of the Cisco Configuration ExtendAir r5005
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir (TDD) Series Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Management Pages
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- VLAN Configuration Page
- Ethernet Rate Limiting
- QoS Configuration Page
- Automatic Channel Selection (ACS) Page
- Syslog Configuration Page
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty Software License and RMA Procedures Agreement
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir (TDD) Series Digital Microwave Radios
ix 203591-011
2013-02-22
Notes for Customers of the Cisco Configuration
ExtendAir r5005
Customers who purchased the Cisco configuration of the ExtendAir r5005 should note the following:
• The Cisco configuration ExtendAir r5005 has an integrated antenna. Sections of the manual that
refer to the rc5005 or any rc models (those with connectors for external antennas) are not relevant.
• The Cisco configuration ExtendAir r5005 is not available in the 5000, 5010, or 5015 variants nor
any 49xx variants. The specifications, connections, and capabilities listed for those models are not
applicable.
• Cisco configuration radios provide specific the following capabilities for regional regulatory
domain compliance, as ordered:
– Certain frequency bands and/or tuning ranges are available and/or blocked from use
– EIRP (maximum output power) limits may be applied
– Channel bandwidth (size) selections may be limited and/or named in accordance with
regulations
– Dynamic Frequency Selection (DFS) may be enforced and not selectable, per regulations
• The Cisco configuration ExtendAir r5005 is provided standard with full Ethernet capacity and
128-bit AES encryption. No license keys are required for capacity, and only 256-bit AES
encryption is available as an upgrade license key.
• The Cisco configuration ExtendAir r5005 is packaged with the integrated AC power injector (not
sold separately). The DC power injector is not provided. Information regarding DC power is not
applicable.