User Manual
Table Of Contents
- ExtendAir® (TDD) Series Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- Notes for Customers of the Cisco Configuration ExtendAir r5005
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir (TDD) Series Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Management Pages
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- VLAN Configuration Page
- Ethernet Rate Limiting
- QoS Configuration Page
- Automatic Channel Selection (ACS) Page
- Syslog Configuration Page
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty Software License and RMA Procedures Agreement
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir (TDD) Series Digital Microwave Radios
136 203591-011
2013-02-22
buzzer timeout selection 54
passwords 8, 34
path obstruction 105
performance degradation 103
Performance page 74
power
system LEDs 25
Power connector 96
power interface 94
Power/Ethernet connector 22
Q
QoS configuration
802.1p based 65
IPv4/IPv6 based 66
MAC DA based 63
MAC SA based 64
VLAN ID based 64
R
radio
default settings 11
grounding 105
initiation tasks 19
installation tasks 19
maximum transmit power setting 51
mounting 6, 21
rebooting 76, 85
Radio A 11
Radio A configuration 7
radio configuration 7
radio firmware files 46
Radio Information page 39
Radio Transmit Power parameter 50
Reboot page 85
receiver threshold 6
record keeping 20
Regulatory Domain Database (RDD) 46
regulatory requirements
EIRP 118
USA 113
repeater 13
RESET button 23
RF connector termination 24
RF Frequency parameter 51
RF interface 94
RF interference 104
RF lightning arrestor 30
RF output power 9
RSL 9
current RSL readings 74
diagnostics 79
Maximum RSL field 75
Minimum RSL Timestamp field 75
monitor for performance 103
RSL Sync 95
RSL voltage 31
S
safety 109
Set to E1 button 57
Set to T1 button 57
shipping box contents 7
site preparation 6
SNMP 17, 43
SNMP Traps 44
specifications 87
Spectrum Analyzer page 81
Swap button 46, 49
sync distribution accessory 96
sync source 16
synchronization 12
System Configuration page 50
system latency 6
system parameters
default settings 27
system performance 74
system reboot 76
system settings
Current BER field 74
Errored Seconds (ES) field 75
grounding 105
Maximum RSL 75
Minimum RSL field 75
Time Since Reset field 75
Unavailable Seconds field 75
system specifications 88
T
T1 Interface Configuration page 57
T1/E1 1&3 connector 22
T1/E1 2&4 connector 22
T1/E1 2&4 LED 23
T1/E1 circuits 57
T1/E1 Configuration page 57
T1/E1 interfaces 94
T1/E1 loopback 59
TDD factors 9