User's Manual

Exalt Communications, Inc.
EX-5r Installation & Management
5000007 28
2006-05-17
Section 5 – Configuration and Management
5.0 Using the Command Line Interface (CLI)
The EX-5r utilizes a CLI through a Telnet (Ethernet) connection as a means to set key
parameters on the system.
5.0.1 Connecting to the Radio with a Telnet Connection
For a Telnet connection to the radio through the Ethernet AUX port, using Windows OS,
perform the following steps:
• Open a Command Prompt, or MS-DOS prompt (Start>Run>cmd)
• Enter the following at the command line of the command prompt window:
C:\>Telnet <IP Address>
Note: The default IP address of the EX-5r is 10.0.0.1
Note: You may reset the IP address to the default address by radio reset (as described in
section 4.2.4)
Note: Your computer needs to be in the same IP subnet as the radio to use the Telnet
function.
5.1 Using the CLI
Using CLI, when prompted, enter the administration level login and password:
The default administration login is admin and password is admin
You may reset to the default administration password by performing a radio reset (as described
in section 4.2.4)
After logging in, there are three menu choices available as shown.
Figure 5-1: Main CLI Menu