User's Manual

Exalt Communications, Inc.
EX-5r Installation & Management
5000007 17
2006-05-17
The pole-mounting bracket is affixed to the pole by using the two band clamp straps that are
provided. Thread the band clamp straps through the mounting bracket, wrap around the pole, and
thread through the adjustment end. Pull the straps by hand as much as possible, and using a
screwdriver, the band clamps should be tightened until the entire assembly is secure.
If the radio was not attached to the bracket, tighten all mechanics of the bracket, and attach the
radio.
For the integrated antenna version, gently loosen the nuts that hold the azimuth adjustment plate
in place. Roughly align the radio by sight, to the rough azimuth of the link, and tighten the
azimuth adjustment nuts.
If required, perform the same function for rough elevation adjustment.
4.1 User Interfaces
This section is intended to provide a brief familiarization of the connectors, controls and
indicators on the device. More details about each item are found in other sections of this
document. The EX-5r connections are shown here:
Figure 4-2: Connections
Table 4-1: Connectors
Connector Type Gender Function
Antenna
(0, 1 or 2)
N F (External antenna version only) Transmission line
connection to antenna (on front face of unit)
T1/E1
(1&2, 3&4)
RJ-48C F Primary ports for User T1 or E1 circuits to traverse
link
Ethernet/Power
(Main/Aux)
RJ-45 F Primary port for power and Ethernet (10BaseT or
100BaseT) to traverse link
GPS Sync RJ-45 F External radio synchronizing source (GPS) input
(Ground)
Threaded
(M5)
Receptacle
F Chassis ground connection (M5 x 0.8 thread)
GPS S
y
nc
T1/E1 3&4
T1/E1 1&2
Power/Ethernet