User's Manual
Table Of Contents
- EX-i Series GigE (FDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zone Configurations
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Allocation Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- MHS Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- Ethernet Aggregation
- Cross Connect (X Connect) Page
- Alarms Page
- MHS Status Page
- Performance Page
- ATPC Statistics Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- PA Control Page
- Spectrum Analyzer
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- EIRP Limits for the United States and Canada
- Licensing 6 and 11GHz Models
- Antennas 5GHz Models
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
EX-i Series GigE (FDD) Digital Microwave Radios
202675-008 71
2016-06-01
MHS Status Page
This page provides information regarding the status of MHS configuration and alarms.
Figure 47 MHS Status page
The ‘local’ radio is the terminal you are logged into, and the ‘partner’ information is the terminal that
is configured as its MHS partner. One of these must be designated as Primary, while the other is
designated as Secondary (see
MHS Configuration Page).
• The RF Status indicates which radio is being used for the RF circuitry of the link and which one is
on standby.
• The Interface Status indicates which radio is being used for the interface circuitry of the link and
which one is on standby
• The Protection Link Status refers to the communications between the PROT ports of the terminals.
• The Configuration status indicates if there are any mis-matches in required configurations between
the two terminals. The following items must match between partner radios:
– Hi/Lo orientation
– one terminal must be primary and the other secondary
– all TDM enabled channels and their respective alarm enabled states
– Ethernet traffic/management, alarming and muting
• The Expansion Link status refers to the communications between the EXP ports on the terminals.