User's Manual
Table Of Contents
- EX-i Series GigE (FDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zone Configurations
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Allocation Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- MHS Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- Ethernet Aggregation
- Cross Connect (X Connect) Page
- Alarms Page
- MHS Status Page
- Performance Page
- ATPC Statistics Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- PA Control Page
- Spectrum Analyzer
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- EIRP Limits for the United States and Canada
- Licensing 6 and 11GHz Models
- Antennas 5GHz Models
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
EX-i Series GigE (FDD) Digital Microwave Radios
70 202675-008
2016-06-01
Table 6 Additional alarm status indicators
Label Status
Expansion Port Alarm When MHS, Frequency Diversity, Errorless Switching, or Aggregation is enabled:
• Green = Expansion Port Data is valid
• Yellow = Expansion Port Data is not valid or missing
Protection Port Alarm When MHS or Errorless Switching is enabled:
• Green = Protection Port connection is valid
• Yellow = Protection Port connection is not valid or missing
MHS Alarm When MHS is enabled:
• Green = MHS configuration is correct and Protection Port data is valid
• Yellow = MHS configuration is mismatched or Protection Port data is not valid or missing
Link Main Alarm When MHS or Errorless Switching is enabled:
• Green = The local radio RF is good
• Yellow = The local radio RF is BER=10e-6 or worse