User's Manual
Table Of Contents
- EX-i Series GigE (FDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zone Configurations
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Allocation Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- MHS Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- Ethernet Aggregation
- Cross Connect (X Connect) Page
- Alarms Page
- MHS Status Page
- Performance Page
- ATPC Statistics Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- PA Control Page
- Spectrum Analyzer
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- EIRP Limits for the United States and Canada
- Licensing 6 and 11GHz Models
- Antennas 5GHz Models
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
EX-i Series GigE (FDD) Digital Microwave Radios
202675-008 67
2016-06-01
Cross Connect (X Connect) Page
This page has two primary purposes. One is to determine the priority of TDM interfaces when ACM is
enabled and allocation for the associated TDM interfaces is different from one modulation to another.
The other is to allow a cross-connect function for port assignments from one end of the link to the
other.
Figure 45 Cross Connect (X Connect) page
For the priority selection function, for example, if allocation has been set to carry 16xT1 interfaces
under all conditions except for the lowest modulation setting, where only 4xT1 are allocated, the
priority 1 through 4 ports would remain active in the lowest modulation setting.
For the cross-connect function, the port numbers at both the near-end and far-end are mapped by the
administrator to determine traffic flow through the radio - for example, allowing traffic on Port 1 of
one radio to be virtually connected to Port 11 on the other. This can relieve the need to commission
external cross-connect or channel banks, or relieve an issue with a bad port or bad connection or cable
to a port by re-prioritizing and re-connecting it.