User's Manual

Exalt Installation and Management Guide
EX-i Series GigE (FDD) Digital Microwave Radios
202675-008 109
2016-06-01
Regulatory Notices
This section presents the Regulatory Compliance Regulations for your country.
United States Compliance
The 6 and 11GHz EX-i Series GigE (FDD) product family operates under FCC Rule Parts 101 as a
licensed device. The 5GHz EXi-Series GigE product family operate under FCC Rule Part 15.407 (b)
(4) (ii) as license-exempt devices. They may only be used as a point-to-point transmission device for
fixed or temporary-fixed (non-mobile) installations. The devices are subject to the following
restrictions:
• Do not use external amplifiers to boost the power or overcome transmission system losses, unless
the specific amplifier/cable/antenna combination has expressly been authorized by the FCC. The
output power must never exceed +30 dBm.
• Cross-border transmissions are expressly prohibited, except with written permission from both the
FCC and the governing body of the neighboring country (Cofetel for Mexico; Industry Canada for
Canada).
• Use only parabolic dish antennas (see Table 7). No other types of antennas (panel, omni-
directional, yagi, and so on) are authorized. For 5GHz models, maximum mid-band gain of
parabolic dish antennas certified is 37.9dBi (6'/1.8m diameter).
Federal Communications Commission (FCC), United States
The device is allowed to be used provided it does not cause interference to other devices. It is not
guaranteed to provide protection against interference from other electronic and radio devices.
(5GHz models only) This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference that may cause
undesired operation.
The system has been tested and found to comply with the limits of a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
Note: The 5GHz model is approved under FCC Rule Part 15.407(b)(4)(ii) for antenna gains greater
than 10dBi.
The 5GHz model cannot be manufactured, marketed, or sold after March 2, 2018 unless it is re-
certified under FCC Rule Part 15.407(b)(4)(i).
Check with Exalt Wireless for status of re-certification.