User's Manual
Table Of Contents
- EX-i Series GigE (FDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zone Configurations
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Allocation Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- MHS Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- Ethernet Aggregation
- Cross Connect (X Connect) Page
- Alarms Page
- MHS Status Page
- Performance Page
- ATPC Statistics Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- PA Control Page
- Spectrum Analyzer
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- EIRP Limits for the United States and Canada
- Licensing 6 and 11GHz Models
- Antennas 5GHz Models
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
EX-i Series GigE (FDD) Digital Microwave Radios
202675-008 93
2016-06-01
PROT (Protection)
EXP (Expansion)
Console (Serial)
Alarm
Power (x2)
Compatible SFP Connectors
The following items have been tested and certified/screened for appropriate safety and EMI/RFI
standards. All other SFP vendors and devices are likely compatible and compliant, but not specifically
tested with the Exalt product.
Duplex Full
Compliance 802.3
Connector RJ-45, female
Connector RJ-45, female
Connector 9-pin sub-D, female
Interface Speed 9600 bps
Compliance EIA-574 DTE (RS-232)
Connector 9-pin sub-D, female
Inputs (2) TTL/Closure
Outputs (2) Relay (Form C)
Connector 3-pin barrier strip
Input Voltage 20–60VDC, 8–4A
Consumption
<160W (<4A @ 48V, <8A @ 24V), 30 or 33dBm models
<100W (2A @ 48V, 4A @ 24V), 25dBm model
Vendor Model Number Type
Avago Technologies AFBR-5710ALZ Multi-Mode Fiber
Avago Technologies AFCT-5710ALZ Single-Mode Fiber
Finisar FCLF-8521-3 Copper
Finisar FTLF-8519P2BTL Multi-Mode Fiber
Finisar FTLF1318P2BTL Single-Mode Fiber
FiberXon FTM-8012C-SLiG Multi-Mode Fiber
Avago Technologies ABCU-5710RZ Copper