User's Manual
Table Of Contents
- EX-i Series GigE (FDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zone Configurations
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Allocation Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- MHS Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- Ethernet Aggregation
- Cross Connect (X Connect) Page
- Alarms Page
- MHS Status Page
- Performance Page
- ATPC Statistics Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- PA Control Page
- Spectrum Analyzer
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- EIRP Limits for the United States and Canada
- Licensing 6 and 11GHz Models
- Antennas 5GHz Models
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
EX-i Series GigE (FDD) Digital Microwave Radios
2 202675-008
2016-06-01
– license key upgrades for 62Mbps, 166Mbps, and 187Mbps full-duplex
– license key upgrades for 4xT1, 8xT1, 12xT1, 16xT1 and/or 1xDS3
– license key upgrades for 128- or 256-bit AES encryption
– license key upgrades for enabling the diversity receiver (1.5+0 models)
• EX-5i/6i-DS3-GigE configured with 20Mbps full-duplex Ethernet and these available
options:
– license key upgrade for 62Mbps, 166 Mbps, and 187Mbps full-duplex
– license key upgrades for 4xT1, 8xT1, 12xT1, 16xT1 and/or 1xDS3
– license key upgrades for 128- or 256-bit AES encryption
– license key upgrades for Lower-6GHz band operation
– license key upgrades for enabling the diversity receiver (1.5+0 models)
– license key upgrades for High-power Tx (6GHz band option only)
• EX-6i-GigE configured with 20Mbps full-duplex Ethernet and these available options:
– license key upgrade for 62Mbps, 166 Mbps, and 187Mbps full-duplex
– license key upgrade for 4xT1
– license key upgrades for 128- or 256-bit AES encryption
– license key upgrade for High-power Tx
– license key upgrade for enabling the diversity receiver (1.5+0 models)
• EX-6i-DS3-GigE configured with 20Mbps full-duplex Ethernet and these available options:
– license key upgrade for 62Mbps, 166 Mbps, and 187Mbps full-duplex
– license key upgrades for 4xT1, 8xT1, 12xT1, 16xT1 and/or 1xDS3
– license key upgrades for 128- or 256-bit AES encryption
– license key upgrade for High-power Tx
– license key upgrades for enabling the diversity receiver (1.5+0 models)
• EX-6i-4DS3-GigE configured with166Mbps, 1xDS3, and these available options:
– license key upgrade for 187Mbps full-duplex
– license key upgrades for 4xT1 and/or 2xDS3, and 3xDS3 and/or 4xDS3
– license key upgrades for 128- or 256-bit AES encryption
– license key upgrade for High-power Tx
– license key upgrades for enabling the diversity receiver (1.5+0 models)
• EX-6i-OC3-GigE configured with166Mbps, 1xOC3, and these available options:
– license key upgrade for 187Mbps full-duplex
– license key upgrades for 4xT1
– license key upgrades for 128- or 256-bit AES encryption
– license key upgrade for High-power Tx