User's Manual
Table Of Contents
- ExtendAir® (TDD) Series
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- Notes for Customers of the Cisco Configuration ExtendAir r5005
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir (TDD) Series Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Management Pages
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- VLAN Configuration Page
- Ethernet Rate Limiting
- QoS Configuration Page
- Automatic Channel Selection (ACS) Page
- Syslog Configuration Page
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
ExtendAir (TDD) Series Digital Microwave Radios
203591-013 137
2016-06-01
buzzer timeout selection 55
passwords 8, 35
path obstruction 106
performance degradation 104
Performance page 75
power
system LEDs 25
Power connector 97
power interface 95
Power/Ethernet connector 22
Q
QoS configuration
802.1p based 66
IPv4/IPv6 based 67
MAC DA based 64
MAC SA based 65
VLAN ID based 65
R
radio
default settings 11
grounding 106
initiation tasks 19
installation tasks 19
maximum transmit power setting 52
mounting 6, 21
rebooting 77, 86
Radio A 11
Radio A configuration 7
radio configuration 7
radio firmware files 47
Radio Information page 40
Radio Transmit Power parameter 51
Reboot page 86
receiver threshold 6
record keeping 20
Regulatory Domain Database (RDD) 47
regulatory requirements
EIRP 119
USA 114
repeater 13
RESET button 23
RF connector termination 24
RF Frequency parameter 52
RF interface 95
RF interference 105
RF lightning arrestor 30
RF output power 9
RSL 9
current RSL readings 75
diagnostics 80
Maximum RSL field 76
Minimum RSL Timestamp field 76
monitor for performance 104
RSL Sync 96
RSL voltage 31
S
safety 110
Set to E1 button 58
Set to T1 button 58
shipping box contents 7
site preparation 6
SNMP 17, 44
SNMP Traps 45
specifications 88
Spectrum Analyzer page 82
Swap button 47, 50
sync distribution accessory 97
sync source 16
synchronization 12
System Configuration page 51
system latency 6
system parameters
default settings 27
system performance 75
system reboot 77
system settings
Current BER field 75
Errored Seconds (ES) field 76
grounding 106
Maximum RSL 76
Minimum RSL field 76
Time Since Reset field 76
Unavailable Seconds field 76
system specifications 89
T
T1 Interface Configuration page 58
T1/E1 1&3 connector 22
T1/E1 2&4 connector 22
T1/E1 2&4 LED 23
T1/E1 circuits 58
T1/E1 Configuration page 58
T1/E1 interfaces 95
T1/E1 loopback 60
TDD factors 9