User's Manual
Table Of Contents
- EX-r Series GigE
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the EX-r Series GigE Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio A/B Configuration
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- T1/E1 Configuration Pages
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Reboot Page
- Manual Page
- Specifications
- 201872-003Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Regulatory Domain Keys
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
EX-r Series GigE Digital Microwave Radios
75 201872-003
2015-10-23
System Specifications, 5.3GHz Band
Frequency Band 5250 to 5350MHz
Tunable Range 5260 to 5332MHz
Output Power (at full power) +13dBm (0.02W)
Output Power (at minimum power) -7dBm
Selectable Channel Bandwidths
8MHz, 16MHz, 32MHz, 64MHz
a
a. A firmware option is required to enable 64MHz BW in jurisdictions where it is permitted. For some
regulatory domains, the 8MHz Bandwidth setting displays as 10MHz, and the 16MHz Bandwidth
setting displays as 20MHz.
Receiver Threshold (BER=10
-6
)
Maximum RSL Mode 1: -25dBm error-free; 0dBm no damage
Non-overlapping channels
8MHz: 10; 16MHz: 5; 32MHz: 2; 64MHz
a
: 1
Regulatory Compliance FCC 15.407; IC RSS-210
FCC ID TTM-105P25M
IC ID 6254A-105P25R
Emission Designator(s)
dBm Mode 1 Mode 2
8MHz -86 -78
16MHz -83 -75
32MHz -80 -72
64MHz
a
-77 -69
8MHz 7M8W7D
16MHz 15M7W7D
32MHz 30M9W7D
64MHz
a
60M8W7D