User's Manual
Table Of Contents
- EX-r Series GigE
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the EX-r Series GigE Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio A/B Configuration
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- T1/E1 Configuration Pages
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Reboot Page
- Manual Page
- Specifications
- 201872-003Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Regulatory Domain Keys
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
EX-r Series GigE Digital Microwave Radios
201872-003 74
2015-10-23
System Specifications, 4.5GHz Band
Frequency Band 4400 to 4900MHz
Output Power (at full power) +24dBm (0.25W) Mode 1, +21dBm Mode 2 (0.13W)
Output Power (at minimum power) +4dBm
Selectable Channel Bandwidths
8MHz, 16MHz, 32MHz, 64MHz
a
a. Certain combinations of Bandwidth, Mode, and Cross-polarization are enabled through software
option.
Receiver Threshold (BER=10
-6
)
Maximum RSL Mode 1: -25dBm error-free; 0dBm no damage
Regulatory Compliance FCC Part 15, EN 60950-1, UL 60950-1
Emission Designator(s)
dBm Mode 1 Mode 2
8MHz -86 -78
16MHz -83 -75
32MHz -80 -72
64MHz
a
-77 -69
8MHz 7M8W7D
16MHz 15M7W7D
32MHz 30M9W7D
64MHz
a
60M8W7D