User's Manual
Table Of Contents
- EX-i Series (TDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the i-Series Radios
- Initial Configuration and Back-to-Back Bench Test
- RF Output Power Setting
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Link Symmetry
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- Access Security Page
- System Configuration Page
- MHS Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- T1/E1 Configuration Pages
- DS3 Configuration Page
- GPS Information Page
- Alarms Page
- MHS Status Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Antennas
- DC Coupler for Antenna Alignment
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Regulatory Domain Keys
- EIRP Limits for the United States and Canada
- EIRP Limits for the European Union and ITU Countries
- EIRP Limits for Australia
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- END USER AGREEMENT
- Copyright Notices
- Index
Exalt Installation and Management Guide
EX-i Series (TDD) Digital Microwave Radios
206501-019 83
2016-05-24
EX-2.4i System Specifications
Frequency Band 2400 to 2483.5MHz
Tunable Range 2406 to 2468MHz
Output Power (at full power) +27dBm (0.5W), Mode 1
+24dBm (0.25W), Mode 2
Output Power (at minimum power) +7dBm
Selectable Channel Bandwidths
8MHz, 16MHz, 32MHz, 64MHz
a
a. 64MHz BW is enabled for the EX-2.4i though a firmware option. 64MHz BW is enabled for the EX-2.4i-16
when the 16xT1/E1 license key is enabled.
Receiver Threshold (BER=10
-6
)
Maximum RSL Mode 1: -25dBm error-free; 0dBm no damage
Non-overlapping channels
8MHz: 8; 16MHz: 4; 32MHz: 2; 64
1
: 1
Regulatory Compliance FCC 15.247; IC RSS-210
FCC ID TTM-102P40I
IC ID 6254A-102P40I
Emission Designator(s)
dBm Mode 1 Mode 2
8MHz -88 -80
16MHz -85 -77
32MHz -82 -74
64MHz
1
-79 -71
Mode 1 Mode 2
8MHz 10M2W7D 9M9W7D
16MHz 17M3W7D 19M0W7D
32MHz 34M7W7D 36M0W7D
64MHz* 60M7W7D 61M3W7D