User's Manual
Table Of Contents
- EX-i Series (TDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the i-Series Radios
- Initial Configuration and Back-to-Back Bench Test
- RF Output Power Setting
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Link Symmetry
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- Access Security Page
- System Configuration Page
- MHS Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- T1/E1 Configuration Pages
- DS3 Configuration Page
- GPS Information Page
- Alarms Page
- MHS Status Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Antennas
- DC Coupler for Antenna Alignment
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Regulatory Domain Keys
- EIRP Limits for the United States and Canada
- EIRP Limits for the European Union and ITU Countries
- EIRP Limits for Australia
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- END USER AGREEMENT
- Copyright Notices
- Index
Exalt Installation and Management Guide
EX-i Series (TDD) Digital Microwave Radios
140 206501-018
2015-11-06
F
factory default settings 28, 49
fade margin 6, 106
File Activation page 51
files
activating stored 51
default configuration file 49
frame length See TDD frame
frequency
center 6
G
gateway (default) 50
Global Positioning System (GPS) kit 12
GPS Information page 66
GPS sync features 10
GPS synchronization 66
grounding 106
GUI
Access Security page 52
Administration Settings page 43
Alarms page 67
browsers supported 35
description 35
Diagnostic Charts page 75
E1 Interface Configuration page 63
Ethernet Interface Configuration page 59
Event Log page 72
File Activation page 51
GPS Information page 66
IP address (default) 35
log in 36
login privileges 37
navigation panel 39, 40
Performance page 70
Radio A configuration 36
Radio Information page 42
Reboot page 80
Spectrum Analyzer page 77
summary status information 39
T1 Interface Configuration page 62
T1/E1 Configuration page 62
VLAN page 60
H
hop 7
hub 13
I
interfaces
alarm 88
Ethernet 88
power 89
RF 88
serial console 88
Sync (In//Out) 89
T1/E1 88
interference 71
interference profile 6
IP address 49
IP subnet mask 50
K
keys
Regulatory Domain Key (RDK) 8, 38, 54
L
License Key 44
lightning arrestor 6
lightning arrestors 31
Line Build Out (LBO) 62
Line Code 62
link 6
orientation 10
synchronization 10
Link Distance parameter 50, 56
link margin 106
Link Name parameter 50
link parameters 39
Link Security Key 44
Link Security Key parameter 50
login names 37
login privileges 37
loopback 62, 63, 64
external (local) 64
external (remote) 64
internal 64
M
master timing 12
Maximum RSL field 71
Minimum RSL field 71
Minimum RSL Timestamp field 71
Mode parameter 55
modes
AUTO SYNC 12
multi-link backbone 13
multi-link network 13
multipath 103
multipath propagation 104