User's Manual
Table Of Contents
- EX-i Series (TDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the i-Series Radios
- Initial Configuration and Back-to-Back Bench Test
- RF Output Power Setting
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Link Symmetry
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- Access Security Page
- System Configuration Page
- MHS Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- T1/E1 Configuration Pages
- DS3 Configuration Page
- GPS Information Page
- Alarms Page
- MHS Status Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Antennas
- DC Coupler for Antenna Alignment
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Regulatory Domain Keys
- EIRP Limits for the United States and Canada
- EIRP Limits for the European Union and ITU Countries
- EIRP Limits for Australia
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- END USER AGREEMENT
- Copyright Notices
- Index
Exalt Installation and Management Guide
EX-i Series (TDD) Digital Microwave Radios
206501-018 139
2015-11-06
Index
A
AC adapter 25, 26
accessory kit contents 7
Administration Settings page 43
administrator privileges 37
Advance Encryption Standard 44
AES 44
AIS enabling//disabling 62
alarm conditions 40
Alarm connector 93
alarms 67, 72, 88
clearing 72
Alarms page 67
AMI 62
antennas
alignment 32, 105
EX-2.4i
Canada 115
EX-5i
Canada 115
US 99
mounting 29
indoor 31
mounting height 6
polarization orientation 6
site preparation considerations 6
system grounding 6
transmission line 29
troubleshooting 105
AUTO SYNC mode 12
B
B8ZS 62
back-to-back bench test 8, 107
back-to-back bench test configuration 107
bandwidth 6
Bandwidth parameter 50, 55
battery source 25
BER 75
browsers 35
C
cables
RF 6
troubleshooting
improper RF cable termination 104
carrier-to-interference tolerance 6
CLI 34
menu options 35
root menu 35
clock 15
connectors
Alarm 93
CONSOLE 34, 94
DC 27
DC Power 95
Ethernet 91
front panel 22
Sync (In//Out) 92
T1/E1 90
Console connector 94
console interface 88
Current BER field 70
Current RSL field 70
D
date and time 44
DC connector 27
DC coupler 33, 100
DC Power connector 95
DC power source 25
DFS 56
Diagnostic Charts page 75
dimensions 82
DIP switch 11
DIP switch (-16 and -DS3 models only) 7
DIP switch (-16 models only) 96
Dynamic Frequency Selection (DFS) 8, 111
E
E1 channels 63
E1 Interface Configuration page 63
effective isotropic radiated power (EIRP) 9
Endpoint Identifier 38, 49, 56
Errored Seconds (ES) field 71
Ethernet 6
Ethernet configuration parameters 50
Ethernet connectors 91
Ethernet interface 88
throughput settings 62
Ethernet Interface Configuration page 59
Event Log page 72
External Alarm Inputs parameter 57
external GPS source 13
external loopback modes 64