User's Manual
Table Of Contents
- Legal Notice
- Open-Source License Information
- About this Document
- General Compliance and Safety
- Regulatory Notices
- EU WEEE
- EU RoHS
- Regulatory Notices (4.9GHz Model)
- Safety Notices
- Exalt Limited Hardware Warranty
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- CLI Screens and Menus
- Exalt Graphical User Interface (GUI)
- Quick-Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- File Transfer Page
- File Activation Page
- Simple Network Management Protocol (SNMP) Configuration
- Alarms Page
- Performance Page
- Event Log Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Reboot Page
- Manual Page
- Troubleshooting
- General Practices
- Typical Indications of Issues
- Improper RF Cable Termination
- Multipath Propagation
- RF Interference
- Path Obstruction
- Misaligned Antenna
- Faulty Antenna
- Improper Grounding
- Insufficient Link Margin
- Moisture in the Transmission System
- Physical Specifications
- Common System Specifications
- EX-2.4i System Specifications
- EX-4.9i System Specifications
- EX-5i System Specifications, 5.3 GHz Band
- EX-5i System Specifications, 5.4 GHz Band
- EX-5i System Specifications, 5.8 GHz Band
- Interfaces
- Back-to-back Bench Testing
- DC Coupler for Antenna Alignment
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Copyright Notices
- Index
Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 50
2007-04-15
Figure 15 Primary front panel connectors (standard models)
Table 4 Connectors
Label Type Gender Function
Antenna N F Transmission line connection to GPS antenna.
T1/E1
(1–4 or 1–16)
RJ-48C F Primary ports for User T1 or E1 circuits to traverse link.
ETHERNET
(MAIN/AUX)
RJ-45 F Primary ports for user Ethernet and/or management data
(10BaseT or 100BaseT) to traverse link.
SYNC
(IN/OUT)
RJ-45 F Internal or external radio synchronizing source (for
example, GPS) input and output.
CONSOLE 9-pin sub-D F Management port (serial) for PC/PDA for Command Line
Interface (CLI) communications.
ALARMS 9-pin sub-D F External alarm inputs and outputs.
GND (Ground) Bantam F Common (return) volt meter test point for measuring
RSL.
RSL Bantam F Voltmeter test point for measuring received signal level.
40–60VDC 6-pin modular M DC power input from DC source or AC adapter.
(Ground) Threaded (M5)
receptacle
F Chassis ground connection (M5 x 0.8 threads).