User's Manual
Table Of Contents
- Legal Notice
- Open-Source License Information
- About this Document
- General Compliance and Safety
- Regulatory Notices
- EU WEEE
- EU RoHS
- Regulatory Notices (4.9GHz Model)
- Safety Notices
- Exalt Limited Hardware Warranty
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- CLI Screens and Menus
- Exalt Graphical User Interface (GUI)
- Quick-Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- File Transfer Page
- File Activation Page
- Simple Network Management Protocol (SNMP) Configuration
- Alarms Page
- Performance Page
- Event Log Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Reboot Page
- Manual Page
- Troubleshooting
- General Practices
- Typical Indications of Issues
- Improper RF Cable Termination
- Multipath Propagation
- RF Interference
- Path Obstruction
- Misaligned Antenna
- Faulty Antenna
- Improper Grounding
- Insufficient Link Margin
- Moisture in the Transmission System
- Physical Specifications
- Common System Specifications
- EX-2.4i System Specifications
- EX-4.9i System Specifications
- EX-5i System Specifications, 5.3 GHz Band
- EX-5i System Specifications, 5.4 GHz Band
- EX-5i System Specifications, 5.8 GHz Band
- Interfaces
- Back-to-back Bench Testing
- DC Coupler for Antenna Alignment
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Copyright Notices
- Index
Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 39
2007-04-15
Table 3 Factory default settings
Parameter EX-2.4i EX-4.9i EX-5i
Frequency 2441 4965 MHz 5788
Transmit Power +7 dBm +4dBm +4dBm
Bandwidth 8MHz 10MHz 8MHz
Mode Mode 1
Link Distance <10 miles
TDD Frame Size 2ms
Link Security Key 000000000000
Administration Password password
User Password password
IP Address 10.0.0.1
IP Mask 255.0.0.0
IP Gateway 0.0.0.0
Ethernet Interfaces Enabled, 100/Full
AUX port NMS Access In-Band
T1/E1 Settings (-16 models) All Enabled, T1, B8ZS, AIS
T1/E1 Settings (std. models) Disabled
Standard models: If radio configuration is unknown, and you do not have access to a
computer and must install the radios immediately, the temporary hardware configuration
key can help to establish a link or perform back-to-back bench testing, by helping to
configure one of the radio terminals to Radio A.
Note: In many cases, the system design will not be identical to the
factory default configuration, and in some cases, these differences prohibit
the installation of the radio. If at all possible, obtain a computer and
configure the radio terminals using the browser-based GUI. See Exalt
Graphical User Interface (GUI) on page 68 for details.
Temporary Hardware Configuration Key (Standard Models Only)
Use the following steps to enable the temporary hardware configuration key:
1. Remove power from the radio.
2. Remove anything connected to the ALARMS port.
3. Connect the key (found in the accessory kit) to the ALARMS port.
4. Hold down RMT button while applying power.
The LEDs toggle through the boot cycle.