User's Manual
Table Of Contents
- Legal Notice
- Open-Source License Information
- About this Document
- General Compliance and Safety
- Regulatory Notices
- EU WEEE
- EU RoHS
- Regulatory Notices (4.9GHz Model)
- Safety Notices
- Exalt Limited Hardware Warranty
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- CLI Screens and Menus
- Exalt Graphical User Interface (GUI)
- Quick-Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- File Transfer Page
- File Activation Page
- Simple Network Management Protocol (SNMP) Configuration
- Alarms Page
- Performance Page
- Event Log Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Reboot Page
- Manual Page
- Troubleshooting
- General Practices
- Typical Indications of Issues
- Improper RF Cable Termination
- Multipath Propagation
- RF Interference
- Path Obstruction
- Misaligned Antenna
- Faulty Antenna
- Improper Grounding
- Insufficient Link Margin
- Moisture in the Transmission System
- Physical Specifications
- Common System Specifications
- EX-2.4i System Specifications
- EX-4.9i System Specifications
- EX-5i System Specifications, 5.3 GHz Band
- EX-5i System Specifications, 5.4 GHz Band
- EX-5i System Specifications, 5.8 GHz Band
- Interfaces
- Back-to-back Bench Testing
- DC Coupler for Antenna Alignment
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Copyright Notices
- Index
Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 31
2007-04-15
Shipping Box Contents
Unless purchased as a spare terminal, the radios are shipped as a complete hop (that is, a
radio link pair consisting of two terminals). An outer box has labeling that indicates the
contents of the box, with the part number and serial number details for both radio
terminals.
Inside the outer box are two identical boxes, each of these boxes is also marked with the
part number and serial number of the individual terminal contained inside the box. The
terminal box contains the following items:
• Radio terminal (configured as Radio B)
• AC adapter
• Accessory kit
¶ Rack mount flanges
¶ Flange mounting hardware (4 x M4 screws; 4 x M4 wave washers)
¶ DC power connector (1)
¶ Temporary hardware configuration key (1 x 9-pin connector, labeled “A”)
¶ Grounding hardware (1 x M5 screw; 1 x M5 wave washer; 2 x M5 flat washers)
¶ Radio A temporary hardware configuration key (for standard models only)
• Registration card
• Quick-start guide
Inspect the outer packaging and the contents of the boxes upon receipt. If you suspect any
shipping damage or issues with the contents, contact Exalt Customer Care.
Note: Register your system as soon as possible. A 2-year Warranty
period applies to products registered within 90 days of purchase. The
Warranty period is reduced to 1-year for unregistered products and
products registered after the first 90 days.