User's Manual
Table Of Contents
- Legal Notice
- Open-Source License Information
- About this Document
- General Compliance and Safety
- Regulatory Notices
- EU WEEE
- EU RoHS
- Regulatory Notices (4.9GHz Model)
- Safety Notices
- Exalt Limited Hardware Warranty
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- CLI Screens and Menus
- Exalt Graphical User Interface (GUI)
- Quick-Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- File Transfer Page
- File Activation Page
- Simple Network Management Protocol (SNMP) Configuration
- Alarms Page
- Performance Page
- Event Log Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Reboot Page
- Manual Page
- Troubleshooting
- General Practices
- Typical Indications of Issues
- Improper RF Cable Termination
- Multipath Propagation
- RF Interference
- Path Obstruction
- Misaligned Antenna
- Faulty Antenna
- Improper Grounding
- Insufficient Link Margin
- Moisture in the Transmission System
- Physical Specifications
- Common System Specifications
- EX-2.4i System Specifications
- EX-4.9i System Specifications
- EX-5i System Specifications, 5.3 GHz Band
- EX-5i System Specifications, 5.4 GHz Band
- EX-5i System Specifications, 5.8 GHz Band
- Interfaces
- Back-to-back Bench Testing
- DC Coupler for Antenna Alignment
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Copyright Notices
- Index
Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 8
2007-04-15
Manufacturer Model # Descri
p
tion Gain dBi (mid-band)
Radio Waves FP.5-5-18 6-inch Panel 18.0
Radio Waves FP1-5-24 1-foot Panel 23.8
Radio Waves FP2-5-28 2-foo
t
Panel 28.0
Radio Waves SP1-5.2 1-foot Dish 22.5
Radio Waves SP2-5.2 2-foot Dish 29.0
Radio Waves HP2-5.2 2-foot HP Dish 28.6
Radio Waves SP3-5.2 3-foot Dish 32.0
Radio Waves SP4-5.2 4-foot Dish 34.8
Radio Waves SP6-5.2 6-foot Dish 37.9
RFS SPF2-52A 2-foot Dish 27.9
RFS SPF3-52A 3-foot Dish 31.4
RFS SPF4-52A 4-foot Dish 33.9
RFS SPF6-52A 6-foot Dish 37.4
RFS SDF4-52A 4-foot HP Dish 33.9
RFS SDF6-52A 6-foot HP Dish 37.4
RFS MA0528-19AN 7.5-inch Panel 19.0
RFS MA0528-23AN 1-foot Panel 23.0
RFS MA0528-28AN 2-foot Panel 28.0
The antenna associated with the EX-5i family shall be mounted in a location that is at
least 10’/3m away from humans that may be subject to long-term or continuous exposure.
Important: Where required by regional regulations, DFS is enabled by the system keys
and cannot be disabled.
Europe/ITU (ETSI and CE Mark)
The EX-5r family complies with ETS 301 893 for the 5.3 and 5.47 GHz bands for
license-exempt use for most countries recognizing ETSI or ITU band assignments. These
bands require Dynamic Frequency Selection (DFS) and Transmitter Power Control (TPC)
for radar-detection and avoidance. There is a +30dBm EIRP limit applied to this band.
Transmitter power must be adjusted accordingly with respect to the RF cabling losses and
antenna gains associated with each terminal.
The EX-5r family complies with ETS 302 502 for the 5.8GHz band. This band is not yet
harmonized for all countries recognizing ETSI or ITU band assignments. Consult the
individual country regulations or your Exalt Communications representative for details.
This band requires DFS and TPC for radar-detection and avoidance. There is a +33dBm
EIRP limit for use of the 10MHz BW setting (called 8MHz on GUI), and a +36dBm
EIRP limit for use of the 20MHz BW setting (called 16MHz on GUI).
All models comply with the requirements for CE Mark (EN 60950) and EMC (EN 301
489-17) when used with the AC adapter included with each model. No substitutions shall