User Manual
Table Of Contents
- ExtendAir (TDD) Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir (TDD) Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- Simple Network Management Protocol (SNMP) Configuration
- File Management Pages
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- VLAN Configuration Page
- Ethernet Rate Limiting
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Regulatory Domain Keys
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir (TDD) Series Digital Microwave Radios
203591-002 119
2009-12-18
P
parameters
buzzer timeout selection 51
passwords 9, 33
path obstruction 88
performance degradation 86
Performance page 62
power
system LEDs 24
Power connector 82
power interface 80
Power/Ethernet connector 21
R
radio
default settings 12
grounding 88
initiation tasks 18
installation tasks 18
maximum transmit power setting 49
mounting 7, 20
rebooting 64, 72
warranty 111
Radio A 12
Radio A configuration 8
radio configuration 8
radio features 6
radio firmware files 44
radio frequency 3
Radio Information page 38
radio mount
enclosure 4
connections 5
indoor 4
connections 5
Radio Transmit Power parameter 48
Reboot page 72
receiver threshold 7
record keeping 19
Regulatory Domain Database (RDD) 44
Regulatory Domain Key (RDK) 40, 48, 100
regulatory requirements
EX-5i FCC EIRP 105
EX-5r Series FCC EIRP 102, 103
USA 95
repeater 13
RESET button 22
RF cable length 5
RF connector termination 23
RF Frequency parameter 49
RF interface 80
RF interference 87
RF lightning arrestor 29
RF output power 10
RSL 10
current RSL readings 62
diagnostics 67
Maximum RSL field 63
Minimum RSL Timestamp field 63
monitor for performance 86
RSL voltage 30
S
safety 92
Set to E1 button 53
Set to T1 button 53
shipping box contents 8
site preparation 7
SNMP 16, 41
SNMP Traps 42
specifications 74
Spectrum Analyzer page 69
Swap button 45, 47
sync source 14
synchronization 13
System Configuration page 48
system latency 7
system parameters
default settings 26
system performance 62
system reboot 64
system settings
Current BER field 62
Errored Seconds (ES) field 63
grounding 88
Maximum RSL 63
Minimum RSL field 63
Time Since Reset field 63
Unavailable Seconds field 63
system specifications 75
T
T1 clocking 22
T1 Interface Configuration page 53
T1/E1 1&3 connector 21
T1/E1 2&4 connector 21
T1/E1 2&4 LED 22