User Manual
Table Of Contents
- ExtendAir (TDD) Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir (TDD) Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- Simple Network Management Protocol (SNMP) Configuration
- File Management Pages
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- VLAN Configuration Page
- Ethernet Rate Limiting
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Regulatory Domain Keys
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir (TDD) Series Digital Microwave Radios
203591-002 117
2009-12-18
Index
A
AC power injector 23
AC power injector kit 24
Administration Settings page 39
administrator privileges 33
Advance Encryption Standard 40
AES 40
AIS enabling//disabling 53
alarm conditions 36
alarms 52, 60
clearing 64
Alarms page 60
AMI 53
antennas
alignment 29, 88
Canada 96
mounting 4, 26
indoor 29
mounting height 7
site preparation considerations 7
transmission line 27
troubleshooting 88
B
B8ZS 53
back-to-back bench test 9, 90
back-to-back bench test configuration 90
bandwidth 6
Bandwidth parameter 49
battery source 23
BER 67
browsers 32
buzzer timeout selection parameter 51
C
cables
Ethernet (CAT5) 9
RF 7
RFC 5
T1/E1 9
troubleshooting
improper RF cable termination 87
center frequency tuning 6
channel bandwidth 6
CLI 31
main menu 31
menu options 31
configuration file 44
connectors 21
GPS/RSL 21
Power/Ethernet 21, 82
T1/E1 1&3 21
T1/E1 2&4 21
TDM 81
contact information 2
Current BER field 62
Current RSL field 62
D
data communication interface 5
date and time 39
DC power source 23
Diagnostic Charts page 67
dimensions 74
documentation, related 2
duplex settings 52
Dynamic Frequency Selection (DFS) 50, 93
E
E1 channels 54
E1 Interface Configuration page 54
effective isotropic radiated power (EIRP) 10
encryption 6
Endpoint Identifier 34, 48
Errored Seconds (ES) field 63
Ethernet configuration parameters 54
Ethernet connectors 82
Ethernet interface 80
throughput settings 53
Ethernet Interface Configuration page 52
Event Log page 64
ExaltCalc tool 11, 86
external loopback modes 55
F
factory default settings 26, 45
fade margin 7, 89
features 6
File Activation page 45, 47
File Transfer page 44
file transfers 44
files
activating stored 47
default configuration file 45
flywheeling 14
frame length See TDD frame
frequency