User's Manual

Exalt Communications, Inc.
r-series Installation and Management Manual
5000007 (ETSI) 38
2007-02-12 (draft)
Figure 13 Radio Information page
Quick-Start
To establish a link on the bench, apply the following basic configurations to the radio terminal.
Use the steps in the Quick Start Guide included with the radio. A summary of the items that
need to be configured are:
• Radio IP address for each end.
¶ Each end must have a different IP address and cannot match the accessing computer’s IP
address or any address assigned if radios are part of a larger network.
¶ It may be required to change the IP address of the accessing computer after changing the
IP address of the radio so that the IP subnet matches.
¶ The radio IP address is listed on the Administration Settings page.
• Set one radio as Radio A.
¶ The radio selected as Radio A must be configured.
¶ Radio A/B selection is the Endpoint Identifier parameter on the System Configuration
page.
¶ Even though both radios are set as Radio B by default, confirm this configuration on the
radio intended to be Radio B.