User's Manual

Exalt Communications, Inc.
r-series Installation and Management Manual
5000007 (ETSI) 22
2007-02-12 (draft)
Radio Ports and Indicators
This section provides a brief overview of the connectors, controls, and indicators on the device.
Details about each item are in other sections of this document. Figure 8 shows the connectors on
the r-Series.
Figure 8 EX-5r connectors
Connector Overview
The primary user interfaces are shown in Figure 8. Table 3 provides details of the connectors.
Detailed pin structures for each connector are in Interface Connections on page 86.
Table 3 Connectors
Connector Description
GPS/RSL (1) Connection to (optional) external GPS antenna for network synchronization.
(2) Antenna alignment RSL voltage (during installation)
T1/E1 2&4 Ports for up to two user T1 or E1 circuits to traverse link, port numbers 2 and 4
T1/E1 1&3 Ports for up to two user T1 or E1 circuits to traverse link, port numbers 1 and 3
Power/Ethernet Connected cables traverse to the power injector (Data+Power side), and provide the following
functions:
• Primary ports for user Ethernet data (10BaseT or 100BaseT) to traverse link
• DC power from power injector
(Ground) Threaded (M5) receptacle
Use a connector cover on all unused connectors for weatherproofing. The
connector covers are included in the accessory kit. Use a safety ring on each
connector to secure the connector covers.
GPS/RSL
T1/E1 2&4
T1/E1 1&3
POWER/ETHERNET