User Manual

Exalt Communications, Inc.
Exalt EX-4.9Series Module Guide
5xxxxxxx 19
2007-07-16
• Do not use external amplifiers to boost the power or overcome transmission system
losses, unless the specific amplifier/cable/antenna combination has expressly been
authorized by the FCC. The output power must never exceed +50 dBm.
• Cross-border transmissions are expressly prohibited, except with written permission
from both the FCC and the governing body of the neighboring country (Cofetel for
Mexico; Industry Canada for Canada).
– Use only parabolic dish antennas or directional flat-panel antennas. No other
types of antennas (omni-directional, yagi, and so on) are authorized. Parabolic
dishes of either grid or solid type are allowed. Maximum mid-band gain of
each type of antenna certified are:
¶ EX-4.9 models:
– Parabolic dish: 26dBi (larger gains are allowed, with Tx power reduction)
– Directional flat panel: 26 dBi (larger gains are allowed, with Tx power
reduction)
–
Industry Canada (IC), Canada
This device complies with RSS-210 of Industry Canada. Operation is subject to the
following two conditions:
4. this device may not cause interference, and
5. this device must accept any interference, including interference that may cause
undesired operation of the device.
Antennas Supported in Canada
The EX-4.9 family has been designed to operate with the antennas listed in Table 2 which
have a maximum gain of 37.9 dBi. Antennas not included in the list or having a gain
greater than 37.9 dBi are prohibited for use with this device. The required antenna
impedance is 50 Ohms.
The antenna associated with the EX-4.9 family shall be mounted in a location that is at
least 10’/3m away from humans that may be subject to long-term or continuous exposure.
Canada Compliance
EX-4.9 models operate under RSS-210 of Industry Canada regulations. Operation is
subject to the following conditions, unless express permission is granted by Industry
Canada to operate in a different manner:
• External amplifiers cannot be used to boost the power or to overcome transmission
system losses, unless the specific amplifier/cable/antenna combination is expressly
authorized by Industry Canada.