User Manual

Exalt Communications, Inc.
Exalt EX-4.9 Series Guide
5xxxxxxx 18
2007-07-16
Region 1 Specifics
Region 1 is designated for USA and Canada installations.
Note: The professional installer is responsible to ensure that RF output power is
properly adjusted to not exceed the regulatory limit.
Federal Communications Commission (FCC), United States
The device is allowed to be used provided it does not cause interference to other devices.
It is not guaranteed to provide protection against interference from other electronic and
radio devices.
The system has been tested and found to comply with the limits of a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the
relevant FCC regulations.
Changes or modifications not expressly approved in writing by Exalt may void the user’s
authority to operate this equipment.
This device must be professionally installed.
To comply with regulations, the output power of this device may need to be adjusted in
accordance to the associated transmission system.
The antenna associated with the EX-4.9 family shall be mounted in a location that is at
least 10’/3m away from humans that may be subject to long-term or continuous exposure.
United States Compliance
The EX-4.9 product families operate under FCC Rule Parts 90 as a licensed device. They
may only be used as a point-to-point transmission device for fixed or temporary-fixed
(non-mobile) installations. The devices are subject to the following restrictions: