User Manual

Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 37
2007-06-25
Table or Rack Shelf Mounting the System
Affix rubber feet or adhesive-backed non-slip pads (not included) near the corners of the
unit along the bottom panel when mounting on a table or a rack shelf. These pads help
keep the radio stable on a wooden or metal surface.
Caution: In many areas, it is necessary to strap the equipment to a
table or rack shelf if mounting in this manner. In case of earthquake or
other shock or vibration, or an accidental pull of a cable, the unit should be
secured from falling. It may also be necessary to secure the AC adapter, if
it is used.
Radio Ports and Indicators
This section provides a brief overview of the connectors, controls, and indicators on the
device. Details about each item are in other sections of this document.
The EX-2.4i front panel is shown in Figure 13. The EX-4.9i and EX-5i front panels are
identical, except for the model number shown in the upper-right corner.
Figure 13 Front panel (EX-2.4i, EX-4.9i or EX-5i)
The EX-2.4i-16 front panel is shown in Figure 14. The EX-5i-16 front panel is identical,
except for the model number shown in the upper-right corner.
Figure 14 Front panel (EX-2.4i-16 or EX-5i-16)
Connector Overview
The primary user interfaces are shown in Figure 15. Table provides details of the front
panel connectors of all radios. Detailed pin structures for each connector are in Interface
Connections
on page 109.