User's Manual

Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 36
2007-01-03
Continue to hold the RMT button until the LEDs stabilize (approximately 45
seconds).
5. Release the RMT button.
The following configurations are reset on the radio:
• IP address = 10.0.0.1
• IP mask = 255.0.0.0
• IP gateway = 0.0.0.0
• Administration password = password
• User password = password
• Endpoint Identifier = Radio A
DIP Switch Configuration (-16 Models Only)
The -16 models have a DIP switch to allow temporary configuration for Radio A and
Radio B. See DIP Switch Settings (-16 Models Only) on page 124 for information on DIP
switch functions.
Radio Synchronization
The radio synchronization feature improves the performance of Exalt radios operating
in the same frequency band and that are collocated (such as in repeater and hub
configurations). Radio synchronization ties radio systems together to operate off of a
common clock system, ensuring that all radios simultaneously transmit and receive, and
thus eliminating near-field interference issues and related radio system coupling.
The synchronization function is not currently available on all Exalt radio
models. A firmware upgrade may be required for models without sync if
sync is desired. Contact your Exalt representative for details.
Synchronization Modes
Synchronization can be accomplished using either an internal or external source. In
either case, one radio in the network must be defined as the primary sync source (A)
radio.
A Global Positioning System (GPS) kit from Exalt is required to implement external
source synchronization. GPS synchronization is not available on all radio models.
Contact your Exalt representative for details.
Synchronization implementation only requires one synchronization source for any
interconnected network. The system also implements a redundancy configuration to
maintain a majority of the synchronization functions in case of primary radio failure.