User's Manual

Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 35
2007-01-03
Table 3 Factory default settings
Parameter EX-2.4i EX-4.9i EX-5i
Frequency 2441 4965 MHz 5788
Transmit Power +7 dBm +4dBm +4dBm
Bandwidth 8MHz 10MHz 8MHz
Mode Mode 1
Link Distance <10 miles
TDD Frame Size 2ms
Link Security Key 000000000000
Administration Password password
User Password password
IP Address 10.0.0.1
IP Mask 255.0.0.0
IP Gateway 0.0.0.0
Ethernet Interfaces Enabled, 100/Full
AUX port NMS Access In-Band
T1/E1 Settings (-16 models) All Enabled, T1, B8ZS, AIS
T1/E1 Settings (std. models) Disabled
Standard models: If radio configuration is unknown, and you do not have access to a
computer and must install the radios immediately, the temporary hardware configuration
key can help to establish a link or perform back-to-back bench testing, by helping to
configure one of the radio terminals to Radio A.
In many cases, the system design will not be identical to the factory
default configuration, and in some cases, these differences prohibit the
installation of the radio. If at all possible, obtain a computer and configure
the radio terminals using the browser-based GUI. See Exalt Graphical
User Interface (GUI) on page 64 for details.
Temporary Hardware Configuration Key (Standard Models Only)
Use the following steps to enable the temporary hardware configuration key:
1. Remove power from the radio.
2. Remove anything connected to the ALARMS port.
3. Connect the key (found in the accessory kit) to the ALARMS port.
4. Hold down RMT button while applying power.
The LEDs toggle through the boot cycle.