Specifications

EXACOM VCR-2020



C) LOOP CURRENT START: (Two wire configuration)

This mode will only record activity on phones that are in line after the VCR-

2020 Console. The telephone line must pass through the console, therefore this

configuration is most effectively used when the console is "co-located" with the

phone to be recorded.

1) On SW1, set switch 3 to the ON position. Set switches 1 and 2 to the OFF

position.

2) Connect a standard phone cable (RJ11) from a phone jack into the VCR-2020

Console at the jack labeled LINE.

3) Connect another RJ11 cable from a phone into the VCR-2020 Console

at the jack labeled PHONE.

4) Test for proper record operation. Off-hook RECORD, on-hook IDLE.

Figure 6: Console Rear Panel Connections for Loop Current Start