Installation Guide

24
shown enlarged
side curve (pos. 2.3)
First place a side curve up against the
edge curve installed on the gable end. You
want to match curvature of the edge curve
with the side curve. This will ensure that
the side curve is installed in the correct
direction.
Slide the side curve (pos 2.3) into the ridge
profile and into the soil profile. Work it
down until it is flush with the glazing then
work the glazing into it.
If necessary you can use a rubber
mallet on the side curve to move
it down. Be careful not to
damage the aluminum.
Tip:
A light grease on the plastic
sliders may help movement.
to step 11:
Continue inserting the side
glazing and side curves.
The connecting plate (V4) is
attached from the inside with screw
hex M6 x 16 and nut M6. This
secures the window crossbar to the
greenhouse.
to step
12:
step 11
Assembly procedure - eaves -
ATTENTION! When using a foundation frame assemble in advance on this soil profile (see pag s 5,
6)
step 12
step 13
to step 13:
Insert the remaining glazing
panels and side curves.