Owner's manual

Before assembling, you should find a safe area to place the trampoline. Measure your yard to find out how much space you have.

Keep the following two parameters in mind

• The minimum space required overhead the trampoline is 24 feet (about 7.3 meters);

• The minimum space required around the trampoline is 8.2 feet (about 2.5 meters).



PLACEMENT

ASSEMBLY

Installation Requirement

(1). Assembly requires 2-3 people, please keep children or kids away from the trampoline and enclosure until

the trampoline is completely installed.

(2). Use gloves to protect your hands from pinch during assembly.

Installation Steps

There are total 3 boxes.

Before assembly, please open all 3 boxes and put all parts on the ground. Check the PART LIST to confirm you have got all correct

parts. If there is part missing or defective, please just contact us at sales@exacme.com or 3235971109 / 8776080775. We will replace

them for free.

Dos

• Ensure the place is clear of any obstacles including but not limited to debris, walls, fences, branches, slopes, and electrical

power wiring;

• Ensure the place is flat and even. If the ground is not level, never try to make it serve as the jumping area;

• Install the trampoline in a well-lighted area;

• Install the trampoline on the lawn without obstacles underneath, surrounded, and overhead because it keeps the trampoline

stable and firm from sliding with traction as well as protects the jumper from severe injuries in case of falling;

• Adjust somewhere a little uneven (only applicable for the place where the rise/gradient is no more than 3 degrees across

the whole space) if you have to place the trampoline there.

Don’ts

• Do not install the trampoline on hard ground such as driveway, asphalt, or concrete;

• Do not install the trampoline on a hill or anywhere the slope is greater than 3 degrees across the whole space.

Step 1 Frame Layout

NOTE: Ensure that the sides of rails

with spring holes face up.