Operating instructions

9-12
SCSI REFERENCE 1012975
CHAPTER 9—MODE SELECT (15h)
9.2.5 CLEANING CONFIGURATION PAGE (PAGE CODE 25h)
The Cleaning Configuration page specifies how the autoloader behaves when
it is configured to autoclean the tape drive.
Page Code – Byte 00, Bits 5 through 0
This field identifies the Clean Configuration page. The value of this field must
be 25h.
Parameter Length – Byte 01
This field indicates the length, in bytes, of the Cleaning Configuration page.
The valid value for this field is 02h (2), which indicates that 2 bytes of data
follow this byte.
Auto – Byte 02, Bit 1
This bit indicates whether the autoloader will use an available cleaning
cartridge to clean the drive automatically when required, as follows:
0 – Do not automatically clean drive.
1 Automatically clean drive when required if a cleaning cartridge is available.
This bit is ignored if the FixEnbl bit is 0.
FixEnbl – Byte 02, Bit 0
This bit indicates whether the autoloader has a fixed cell reserved for a
cleaning cartridge, as follows:
0 – No cleaning cartridge reservation
1 – Highest numbered Storage Element reserved for cleaning cartridge
When the FixEnbl is set to 1, the storage element with the highest element
address is reserved for a cleaning cartridge. That storage element is then
unavailable for storing a data cartridge. Refer to the Magnum 1x7 LTO
Autoloader Product Manual more information about the autoloader’s Autoclean
option.
Bit
Byte
7 6 5 4 3 2 1 0
00 Reserved Page Code (25h)
01 Page Length (02h)
02 Reserved Auto FixEnable
03 Reserved