Operating instructions

8-8
SCSI REFERENCE 1012975
CHAPTER 8—LOG SENSE (4Dh)
0Dh Autoloader
Pick Retry
W There is a potential problem with a drive ejecting cartridges short or
with the autoloader mechanism picking a cartridge from a cell.
This warning is for information purposes only. No action needs to be
taken at this time.
1. Inspect the autoloader to see if any visible problems exist.
2. Insert a cartridge and try the operation again.
3. If the problem persists, contact Exabyte Technical Support (see
page iii) or your service provider.
0Eh Autoloader
Place Retry
W There is a potential problem with the autoloader mechanism placing
a cartridge into a cell. This warning is for information purposes only.
This warning is for information purposes only. No action needs to be
taken at this time.
1. Inspect the autoloader to see if any visible problems exist.
2. Insert a cartridge and try the operation again.
If the problem persists, contact Exabyte Technical Support (see
page iii) or your service provider.
0Fh Drive Load
Retry
W There is a potential problem with the robot or drive when placing a
cartridge into a drive. This warning is for information purposes only.
No action needs to be taken at this time.
1. Inspect the cartridge to verify compatibility.
2. If the problem persists, contact Exabyte Technical Support (see
page iii) or your service provider.
10h Autoloader
Door
I The operation has failed because the cartridge access port door is
open.
1. Clear any obstructions from the cartridge access port door.
2. Close the cartridge access port door.
3. If the problem persists, contact Exabyte Technical Support (see
page iii) or your service provider.
This flag is cleared when the cartridge access port door is closed.
14h Autoloader
Security
Mode
I The security mode of the autoloader has been changed. The
autoloader has either been put into secure mode or taken out of
secure mode. This is for information only. No action is required.
15h Autoloader
Offline
I The autoloader has been taken offline or powered off and is
unavailable for use.
16h Autoloader
Drive
Offline
I The tape drive inside the autoloader has been taken offline. This is for
information purposes only. No action is required.
17h Autoloader
Scan Retry
I There is a potential problem with the bar code label or the scanner
hardware in the cartridge loader. This flag is cleared when the next
move command is received.
Table 8-2 Parameters returned for the LOG SENSE TapeAlert page (continued)
Parameter
Code
Flag Name Type
a
Description and Corrective Action