Operating instructions

SEPTEMBER 2005 MAGNUM 1X7 LTO AUTOLOADER

7-1

LOG SELECT (4Ch)

7.1 ABOUT THIS COMMAND

The LOG SELECT command allows you to reset the statistical information

maintained by the autoloader to zero. The LOG SELECT command does not

transfer any parameters to the autoloader and does not include any parameter

pages.

7.2 WHAT YOU SEND TO THE AUTOLOADER

Byte 01, Bit 1 – PCR (Parameter Code Reset)

This field specifies whether the autoloader should reset all of the parameters

or only selected parameters, as follows:

0 – Do not reset any parameters.

1 – Reset all of the parameters.

Note: If you set the PCR bit to 1, be sure that the Parameter List Length is 0.

Otherwise, the autoloader will return Check Condition status with the

sense key set to Illegal Request (5h), the ASC and ASCQ set to 24h and

00h.

SP (Saved Page) – Byte 01, Bit 0

The autoloader does not support the saved page function. The valid value for

this field is 0.

Bit

Byte

7 6 5 4 3 2 1 0

00 01001100

01 Reserved PCR SP

Reserved

…

09 00 Reserved 00