Operating instructions

A-14
SCSI REFERENCE 1012975
CHAPTER A—ERROR CODES
04h 00h 06h Bh O, B,
D, A, S
11 IO Process terminated. SCSI data
transfer aborted.
05h 44h 00h 4h T, L, D 8, 13, 12 Internal target fail. (Software error.)
Firmware consistency failure.
05h 4C 00 02h L, D 8, 11,
12, 13
Logical unit failed self config. The
bootblock code is active and normal
functional code cannot be started.
06h 44h 00h 4h T, L, D 8, 13, 12 Internal target fail. (Software error.)
Firmware consistency failure.
07h 44h 00h 4h T, L, D 8, 13, 12 Internal target fail. (Software error.)
Firmware consistency failure.
08h 45h 00h Bh B, L,
D, S
8, 11,
12, 13
Select/Reselect fail. A SCSI selection or
reselection failed. The host rejected the
Identify message sent by the autoloader
after the autoloader reselected the host.
08h 47h 00h Bh B, L,
D, S
8, 17,
11, 12,
13
SCSI parity error. The command was
aborted because of a SCSI bus parity error.
08h 48h 00h Bh B, L,
D, S
8, 17,
11, 12,
13
Initiator detected error. Operation
aborted.
Either the message system was disabled
and the autoloader discovered a parity
error on the SCSI bus, or the message
system was enabled and the initiator
rejected a Restore Data Pointers message
that the autoloader sent to recover from a
parity error. Or, all parity error retries were
exhausted.
08h 4Ah 00h Bh B, L,
D, S
8, 17,
11, 12,
13
Command phase error. A SCSI phase
error occurred during the command
phase.
08h 4Bh 00h Bh B, L,
D, S
8, 17,
11, 12,
13
Data phase error. A SCSI phase error
occurred during the data phase.
09h 15h 81h 4h T, L, D 8, 14,
12,13
Pick failure. The cartridge loader could
not pick a cartridge because of
mechanical problems.
09h 15h 83h 4h T, L, D 8, 14,
12,13
Put failure. The cartridge loader could not
place a cartridge because of mechanical
problems.
Table A-3 REQUEST SENSE error information (FSC, ASC, ASCQ, and SK (continued)
FSC
ASC
(byte 12)
ASCQ
(byte 13)
Sense
Key
Cause ERP SCSI Error Message and Description