Operating instructions

A-10
SCSI REFERENCE 1012975
CHAPTER A—ERROR CODES
48h 00h 08h Bh B, L,
D, S
8, 17,
11, 12,
13
Initiator detected error. Operation
aborted.
Either the message system was disabled
and the autoloader discovered a parity
error on the SCSI bus, or the message
system was enabled and the initiator
rejected a Restore Data Pointers message
that the autoloader sent to recover from a
parity error. Or, all parity error retries were
exhausted.
4Ah 00h 08h Bh B, L,
D, S
8, 17,
11, 12,
13
Command phase error. A SCSI phase
error occurred during the command
phase.
4Bh 00h 08h Bh B, L,
D, S
8, 17,
11, 12,
13
Data phase error. A SCSI phase error
occurred during the data phase.
4C 00 05h 02h L, D 8, 11,
12, 13
Logical unit failed self config. The
bootblock code is active and normal
functional code cannot be started.
4Eh 00h 02h Bh B, L,
D, S, A
8, 11,
12, 13
Overlapped commands attempt.
Overlapped commands attempted. Bad
initiator-target-LUN (ITL) nexus.
53h 00h 1Fh, 20h 03h I 10 Media Load/Eject fail. Media removal
prevented.
53h 02h 17h 5h O, S, A 5, 8 Media removal not allowed. The
autoloader cartridge access port door
cannot be opened because the operation
was prevented with a PREVENT/ALLOW
MEDIUM REMOVAL command.
5Bh 01h 00h 6h I 11 Threshold condition met. Log threshold
met. (For additional information about
this error, look at the Log Parameter Page
Code and Log Parameter Code bytes in
the REQUEST SENSE data.)
5Bh 02h 00h 1h I 11 Log counter at max. Log parameter
overflow. (A cumulative counter reached
its maximum value of all FFs.)
Table A-2 REQUEST SENSE error information (ASC, ASCQ, FSC, and SK) (continued)
ASC
(byte 12)
ASCQ
(byte 13)
FSC
Sense
Key
Cause ERP SCSI Error Message and Description